Oil based hybrid varnish

Instructions

Before you begin:

Make sure the product is at room temperature. Stir the varnish with a stick so that the matter at the bottom of the container peels off and blends perfectly with the mixture before starting.

Surface preparation:

Bare wood: Sand with a 120 or 150 grit sandpaper. Do not use steel wool. Vacuum the dust and wipe off with a clean, dry cloth.
Varnished wood: The surface must be dry, clean and free of dust, mold, wax, grease and moisture. Wash the surface with SamaN’s TSPeco and lightly sand with a 150 grit sandpaper.
Stained wood: Ensure that the surface is completely dry before applying the product. This will prevent the pigments from rising up into the varnish resulting in an uneven finish.

Application:

• Apply 2 to 3 coats of SamaN’s hybrid varnish following the direction of the wood grain with a good quality brush, an 8 mm lint-free roller or an HVLP paint gun.
• Sand between coats with a 180 grit sandpaper.
• Vacuum sandblasting dust and wipe with a clean, damp cloth to remove any residue.
• Repeat this process between each coat of varnish to be applied.

Drying time:

• Let it dry for 1 to 2 hours between coats.
• Wait 24 hours before allowing light traffic.
• Wait one week for heavier traffic or to lay a rug.

Cleaning tools:

Clean all tools and equipment with hot soapy water immediately after use.

Contenues téléchargeables

Downloadable content